KIT-GASKET 6V4762 - Caterpillar

Illustration 1 g02292576
Schematic of the 5 VDC sensor supplyThis diagnostic code is associated with the 5 VDC power supply of the machine electronic control module (ECM). The diagnostic code can be active even when no components are connected to the 5 VDC supply.The CID 262 FMI 6 diagnostic code is activated when the ECM detects an above normal current for the 5 VDC power supply.The following causes could signal this diagnostic code:
The power supply circuit is shorted to a ground source.
The ECM has failed. A failure of the ECM is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the problem has been corrected. Verify that the CID 262 FMI 6 diagnostic code is active before performing this procedure.System Response:Level 1 warning will be generated.Test Step 1. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Perform the following:
Visually inspect the harness connectors.
Clean the contacts of the harness connectors.
Visually inspect the insulation of the wires for damage that is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Reconnect all harness connectors. Verify the following:
Connectors are fully seated.
The clips for each connector are fastened securely.
Use the Cat Electronic Technician (Cat ET) service tool in order to perform a wiggle test on the machine wiring harness. The wiggle test can detect intermittent shorts or opens in the machine wiring harness.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 262 FMI 6 diagnostic code is active.Expected Result:The CID 262 FMI 6 diagnostic code is active.Results:
OK - The CID 262 FMI 6 diagnostic code is active. The problem has not been corrected. Proceed to Test Step 2.
NOT OK - The CID 262 FMI 6 diagnostic code is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors. Resume normal machine operation.STOPTest Step 2. CHECK THE POWER SUPPLY AT THE ECM
Turn the disconnect switch and the key start switch to the OFF position.
Insert a jumper wire in "J1-8" on the ECM. Connect the other end of the jumper wire to a ground location
Turn the disconnect switch and the key start switch to the ON position.
Measure the voltage at the ECM pins between the contact "J1-11" of the power supply and the ground location.Expected Result:The voltage measurement is 5.0 0.4 VDC.Results:
OK - The voltage measurement is 5.0 0.4 VDC. The voltage is correct. The ECM power supply is correct. Proceed to Test Step 3.
NOT OK - The voltage measurement is less than 5.0 0.4 VDC. The ECM power supply is not correct.Repair: A failure of the ECM is unlikely. Exit this procedure and perform this procedure again. Prior to replacing an ECM, always contact the technical communicator at your dealership for possible consultation with Caterpillar. This consultation