KIT-SEAL 7I7326 - Caterpillar

Disconnect clip (25).
Illustration 13 g03659897
View of the left front side of the transmission.
Disconnect tube assembly (26) from the transmission.
Illustration 14 g03659906
View of the front left corner of the transmission.
Disconnect bracket (27).
Illustration 15 g03659911
Disconnect filler neck (28).
Illustration 16 g03659917
Upper rear left side of the transmission.
Disconnect tube assembly (29). Disconnect harness assembly (30) from the end of tube assembly (29).
Illustration 17 g03659927
Illustration 18 g03659934
Disconnect hose assembly (31). Disconnect hose assembly (34). Remove three bolts (33). Reposition valve (32) in order to disconnect harness assemblies (35). Remove valve (32).
Illustration 19 g03659939
Remove bracket assembly (36).
Illustration 20 g03659946
Disconnect bracket (37) from the transmission. Disconnect clips (38) and reposition hose assemblies (40) off to the left side of the machine. Remove heat shield (39).
Illustration 21 g03659962
Position Tooling (A) on suitable cribbing on the machine platforms. Attach Tooling (A) to engine lift bracket (41). Apply suitable tension to Tooling (A) to support the engine when the transmission is removed.
Illustration 22 g03660000
Attach Tooling (B) to the front and rear of transmission (42). Attach a suitable lifting device to Tooling (B) on the rear of the transmission. Attach Tooling (C) to Tooling (B) on the front of transmission (42). The weight of transmission (42) is approximately 771 kg (1700 lb).
Apply suitable tension to Tooling (C) and the suitable lifting device to support the weight of transmission (42).
Illustration 23 g03660052
Remove bolts (43).
Illustration 24 g03660082
Remove bolt (44). Use a second person to support transmission mount (46). Remove bolts (45) and transmission mount (46). Repeat for the opposite transmission mount.
Illustration 25 g03660136
Separate transmission (42) from the flywheel housing. Use Tooling (C) to lower the front end of the transmission to a suitable angle. Note: Changing the angle of transmission (42) will shorten the profile of the transmission and will aid in the removal process.
Slowly raise transmission (42) out of the machine. Installation Procedure
Install transmission (42) in the reverse order of removal.
Install bolts (43) to the following torque 70 15 N m (52 11 lb ft).
Install bolts (44) to the following torque 520 70 N m (384 52 lb ft).