KIT-BEARING 7N3193 - Caterpillar

Illustration 1 g06265947
Table 1
Item Qty Part Specification Description
1 6 0S-1594 Bolt Use the following bolt tightening sequence to tighten the clamp bolts:
Place the clamp assembly so that the clamp assembly is snug against the tube assembly.
Tighten the clamp assembly to the elbow.
Tighten the clamp assembly to the tube assembly.
2 2 0S-1571 Bolt
3 2 109-2332 O-Ring Seal Lightly, lubricate the bore with the fluid that is being sealed.
4 1 2W-1635 Spring Length under test force is 102.0 mm (4.02 inch).
Test force is 518 26 N (116 6 lb).
Free length after test is 143.4 mm (5.65 inch).
5 1 2W-1969 Bypass Valve Valve must open with a pressure difference of 180 20 kPa (26 3 psi).
6 2 7N-7697 Plunger Valves must start to open at a pressure difference of 130 30 kPa (19 4 psi) .
Valves must be fully open at a pressure difference of 200 30 kPa (29 4 psi).
7 2 6B-9202 Spring Length under test force is 68.3 mm (2.69 inch).
Test force is 84.5 to 99.6 N (19.0 to 22.4 lb).
Free length after test is 112.7 mm (4.44 inch).