KIT-OUTPUT TERMINAL 7N7807 - Caterpillar

The EMCP 3 Monitoring Software can be used in order to control a generator set over the SCADA data link. The EMCP 3 Monitoring Software can be used in order to monitor a generator set over the SCADA data link. The EMCP 3 Monitoring Software functionality is available on the EMCP 3.2 and the EMCP 3.3.Illustration 1 shows the default control panel that is provided with the EMCP 3 Monitoring Software. The control panels can be edited or created. Refer to the "Creating a Control Panel View" section of this document.
Illustration 1 g01457718
Default control panel that is provided with the EMCP 3 Monitoring SoftwareSoftware Set Up
Connect a computer to the EMCP 3. The SCADA data link must be used. Follow the instructions that are located in the "EMCP 3 Monitoring Software Quick Start Guide" section of this publication. After the program launched, a login dialog will appear. A user name and a password are required. Use the default user name "administrator". Enter "admin" for the password. Refer to Illustration 2.
Illustration 2 g01457841
Log on screenAdd Device
Click on "Network".
Select "Add Device" or right click on the cable symbol that is located at the top left corner of the dialog. The symbol is located near the "Offline" text that is on the dialog.
Select "Add Device". The "Add a Device" dialog will appear. Refer to Illustration 3.
Illustration 3 g01457842
Device Name
Perform the following steps in order to designate a "Device Name".
Type a desired name for the device in the "Device Name" field.
Click on the arrow that is for the "Device Type". Select the desired device type from the drop-down menu.
Click on the arrow that is for the "Node Address". Select the desired "Node Address" from the drop-down menu. Refer to Illustration 3.Note: Ensure that the node address matches the "SCADA Data Link Slave Address" set point that is on the EMCP 3.Note: The "SCADA Data Link Slave Address" set point data can be accessed with the EMCP 3. Access the SCADA Data Link Slave Address Set Point
Perform the following steps in order to access the SCADA data link slave address set point.
Begin at the main menu.
Select "Configure".
Click "Set Points".
Select "Network".
Select "Data Link – SCADA".Check the Online Configuration Settings
Use the following steps in order to check the online configuration settings:
Select "Network".
Click "Online Configuration" or right click the cable symbol that is located at the top left corner of the dialog. The symbol is located near the "Offline" text that is on the dialog. Select "Online Configuration".
Verify that the interface connection is correct. Verify that the baud rate and the parity match the settings that are programmed in the EMCP 3. Refer to Illustration 4.Note: The interface connection settings, the baud rate settings, and the parity settings can be accessed with the EMCP 3. In order to access the settings, refer to procedure in the "Access the SCADA Data Link Slave Address Set Point" section.
Illustration 4 g01457843
If desired, create a simple test. Select "Edit".
Select "Control Panel Configuration".Add a Control
Select "Edit".
Select "Add Control".
Click "Digital Display" or click the "Digital Display"