KIT-SEAL 7W0539 - Caterpillar

Illustration 147 g06199847
(8) BACK button
(9) HOME button
(81) Tip-Off – TriggerNote: Ensure that the Tip-Off Trigger (81) is set to Manual. Both the Auto and Disabled triggers will cause the Manual Tip-Off button to be hidden on the Payload screen’s right side hotkey buttons.Note: For more information on setting the Tip-Off Trigger to Manual mode, refer to the following section in this manual:
Payload > Settings > Tip-OffPayload Lower Information Display Banner
Note: The Cat® Production Measurement (CPM) feature must be installed.The Payload Banner will appear in the Lower Information Display Banner, but only in the Rear View Camera page. This is done so that the operator is able to monitor the payload settings while using the rear view camera.The Rear View Camera screen appears when the operator places the machine gear into REVERSE.When the operator places the machine gear into either FORWARD or NEUTRAL, the Payload Performance page will reappear.Note: The image shown in the Rear View Camera screen will be a mirrored image.Whenever the machine is in the Rear Camera mode, the following indicators shown on the Payload Performance Page are also shown in the Lower Information Banner:
SUMMED TRUCK WEIGHT Indicator (106): Shows when the Cat Production Measurement is either in “Normal” or “Tip-Off Weigh Mode”.
TARGET TRUCK WEIGHT Indicator (107): The number shows the Weight Remaining data.
CURRENT BUCKET WEIGHT Indicator with the Green Frame (108): Appears only if the Cat Production Measurement is installed.
Illustration 148 g06199859
Whenever the machine is in the Rear Camera mode, the following indicators shown on the Payload Performance Page are also shown in the Lower Information Banner.
(7) Payload Lower Information Display Banner
(106) SUMMED TRUCK WEIGHT Indicator
(107) TARGET TRUCK WEIGHT Indicator
(108) CURRENT BUCKET WEIGHT Indicator with the Green FramePayload Lower Information Display Banner Messages
The “Lift Too High - Lower Bucket” and the “Lift Too Low - Raise Bucket” messages will remain in the Payload Lower Information Display Banner (7) until the situation has been corrected.However, the Payload Lower Information Display Banner will also show the following messages that will appear on the page for three (3) seconds:
Static Reweigh Bucket
Weight w/o (without) shifting - Lift Pressure Change During Weigh
Keep Constant RPM - Excessive Lift Speed Change
Reweigh using detent - Lift Too Jerky During Weigh
Fully Rackback Bucket - Bucket Not Fully Racked
Weigh w/o (without) stopping - Lift Stopped During Weigh
Weight at higher RPM - Lift Too Slow To WeighNote: For more information on setting the Payload’sweigh range, refer to the following section in this manual.
Payload > Settings > Weigh RangeCAMERA Button
Illustration 149 g06201053
(5) CAMERA buttonTo enhance the safety around the machine, the Information Display will provide a visual and audible indication when radar detects an object.Note: The Cat® Object Detection System does not have to be installed.Note: The camera must be installed.
Illustration 150 g06201055
(5) CAMERA Hotkey button (showing a single camera) with Performance Page 1 (Home page)
(109) Direction Indicator (Showing the machine gear to be in NEUTRAL)To launch the Rear View Camera other than during the startup mode, press the CAMERA button (5). The REVERSE camera is the default camera and is