KIT-HYD CYL SEAL 7X2868 - Caterpillar

Modem - Configuration
Note: The modem is a purchased option.
Connect a computer equipped with UPSView to the board for the parallel cabinet interface (PCI) terminal "J6" in the system cabinet.
Boot up the computer and execute UPSView application.
Select "Connection" drop-down menu and select "Connect".
Illustration 1 g03420642
UPSView Connect Select "Enter Password" menu option in order to view the "Enter User Name / Password" dialog box.
Illustration 2 g01273854
Enter Password
Enter a valid "User Name" and "Password".Note: A "User Name" and a "Password" are required from Active Power to enable the modem. Contact Caterpillar technical support for more information.
Select the "Op. Params" drop-down menu.
Illustration 3 g01273856
"Op Params"
Select "Op. Group 5: Internal CAN Enable, Modem Enable" from the "Op. Params." drop-down menu.
Illustration 4 g01273859
Modem Enable
Set the "Enter new valve for Modem Enable" to "1" and press "Send".
Illustration 5 g01273861
"Parameter Change"
Select the "Op. Group 5: Internal CAN Enable, Modem Type" from the "Op. Params." drop-down menu.
Illustration 6 g01273862
"Modem type"
Select the type of the modem that is being installed from the following list.
Table 1
Types of Modems    
2     3 Com Courier V. Everything External    
4     Zoom    
Select "Enter new value for Modem Type" (2) for 3 COM Courier V or select "Zoom " (4) . Press "Send".
Illustration 7 g01273863
Send
Press "Control Q" on the PC key board in order to initialize the modem. Press "Y" in order to acknowledge the modem.The configuration of the modem is complete.
Illustration 8 g01273864
Dip switches for only the 3COM "Courier V. Everything" modem (1) Modem dip switches
Turn the modem over and set the DIP switches (1) to match the values listed in Table 2.
Table 2
Switch settings for the 3 Com Courier V. Everything Modem    
Switch     Position    
1     On ("DTR Always On")    
2     On ("Numeric Result Codes")    
3     On ("Display Result Codes")    
4     On ("No Echo Offline Commands")    
5     Off ("Auto Answer on Ring")    
6     Off ("Normal Carrier Detect")    
7     Off ("Display All Result Codes")    
8     On ("Enable AT Command Set")    
9     Off ("Disconnect with +++")    
10     Off ("Load NVRAM Defaults")