KIT-SEAL 8C6386 - Caterpillar

Introduction
This Special Instruction provides installation procedure for Ethernet Adapter for VIMS on certain Cat products.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method, or operating technique that is used only recommended by Caterpillar. Also, ensure the safety to use.The operation, lubrication, maintenance, or the repair procedures that are used should not damage the products.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
When replacement parts are required for this product Caterpillar recommends using Caterpillar replacement parts or parts with equivalent specifications including, but not limited to, physical dimensions, type, strength and material.Failure to heed this warning can lead to premature failures, product damage, personal injury or death.
PL52x 435-7838 Adapter As installation work instruction
Perform the following steps to install the 435-7838 Adapter As.
Illustration 1 g03495396
Illustration 2 g03495397
Remove Ethernet receptacle from the PL52x Ethernet adapter.
Illustration 3 g03495398
Remove four Ethernet sockets from 70-pin connector on PL52x ECM. Pin 1 orange wire, Pin 2 white wire, Pin 14 green wire, and Pin 15 yellow wire.
Illustration 4 g03495400
Insert the four removed sockets and place into the 8-pin connector lining up the colors. Insert green wire into pin 8. Insert yellow wire into Pin 7. Insert orange wire into Pin 6. Insert white wire into Pin 5.
Illustration 5 g03495401
Ensure that sockets are fully seated.
Illustration 6 g03495402
Insert orange tab to secure sockets.
Illustration 7 g03495403
Insert sockets from Ethernet adapter harness into 70-pin connector. Pin 1 orange wire, Pin 2 white wire, Pin 14 green wire, and Pin 15 yellow wire.
Illustration 8 g03495406
Ensure that sockets are secure in 70-pin connector by checking the bottom side of the connector.
Illustration 9 g03495408
Secure the Ethernet adapter to the rest of the harness with tie straps.