KIT-SEAL 8T1370 - Caterpillar

REBE7922-00
22Dec2011
U-585
O-511
Before/After
PRODUCT SUPPORT PROGRAM FOR REWORKING THE HARNESS AT THE ECM CONNECTOR ON CERTAIN C9.3, C13, C15, AND C18 INDUSTRIAL ENGINES
1408 PS43474
This Program must be administered either before or after failure.In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS43474" as the Part Numberand "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and "T" as the SIMS Description code.If administered after failure, use "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code.
The information supplied in this service letter may not be valid after the termination date of this program.Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
TERMINATION DATE
31Dec2013
PROBLEM
The wiring for the engine indicator lamps are inserted into incorrect locations on the ECM connector on 367-7017 and 367-7018 Harnesses. This causes the engine warning lamp to illuminate when the engine shutdown lamp should illuminate, and for the engine shutdown lamp to illuminate when the engine warning lamp should illuminate.
AFFECTED PRODUCT
Model Identification Number
C13 KWJ00179, 218, 322, 1086, 1089
C15 LDN01028, 1055
C18 BDN01056
C9.3 C9N00517-00518, 573-574, 597, 600, 605, 684-685, 698-699, 701-703, 746, 798-799, 802-804, 848, 862-865
PARTS NEEDED
No parts needed for this program
ACTION REQUIRED
Rework procedure involves changing the pin location for two wires on the engine ECM P1 connector.
Use a Deutsch pin/socket removal tool to remove the wires from engine ECM P1 connector pin 28 and pin 29. Insert the red wire F404-CM4 into pin 28. Insert the green wire F420-CM5 into pin 29.
Image1
SERVICE CLAIM ALLOWANCES