KIT (master cylinder) 9J5193 - Caterpillar

Empty Bucket Calibration
The first calibration is the empty bucket calibration. To perform the Empty Bucket Calibration, follow the steps below:
Illustration 4 g06004904
Next Button in the Display Screen
(1) Next button is used to proceed to the next step
Select the Empty Bucket Calibration. The button will turn blue and the Empty Bucket Calibration Warning Screen will appear.
Read the Warning Screen using the Down Arrow to progress through the pages.
Press "OK". The button will turn blue and the Empty Bucket Calibration start screen will appear.
Select the "OK" button. The button will turn blue and the Empty Bucket Calibration Setup Conditions screen will appear.
Use the Down Arrow to scroll through all the Setup Conditions.
Once the Setup Conditions are met, press the Next button (1). Conditions include:
Set ride control to the AUTO or OFF position (If equipped).
Verify that the bucket is empty.
Select the "OK" button. The button will turn blue and the remaining Setup Condition Screens will appear if necessary. If the Setup Conditions have been met, the screen will skip that step automatically. Conditions include:
Exercise implements to warm hydraulic oil above 40° C (104° F). If the hydraulic oil is dropped below 30° C (86° F) after passing this step, the calibration will revert to this step.
Slowly place the bucket into the full rackback position.
Slowly lower the linkage to the minimum position and bottom out the lift cylinders.
Set Engine Speed to High Idle.Note: If at any point during the calibration the setup conditions are no longer met, the calibration will return to the unmet condition step. All steps completed after this unmet condition will need to be completed again.
Release the Levers. The operator will be warned that the next set of lifts will be performed at Slow Lift Velocity.
Press the Next button (1).
Lift and lower the empty bucket at least two times. If the second full lift does not match the first full lift, the operator will be prompted to lift the empty bucket again. The procedure should be repeated until the operator is instructed to release the lever.Note: The lift must be representative of a typical empty bucket lift. Two consecutive lifts must match sufficiently for the lift to be representative of a typical empty bucket lift. If consecutive lifts do not match, verify the following:
Lift arm motion is smooth and of a consistent speed through the lift
Linkage is properly lubricated
Hydraulic system is working properlyNote: If at any point during the calibration the setup conditions are no longer met, the calibration will return to the unmet condition step. The slow velocity calibration has been saved and will not need to be performed again.
Release the Lever. The operator will be warned that the next series of lifts will be at full raise velocity.
Press the Next button (1).
Lift and lower the empty bucket at least two times. If the second empty lift does not match the first empty lift, the operator will be prompted to lift the empty bucket again. The procedure should be repeated until the empty bucket weight calibration success screen is