KIT-GASKET 9X6602 - Caterpillar

The AS450 angle sensor communicates with the system over J1939 CAN 1 and will provide frequent updates regarding the pitch and roll of the machine. The Cat Compaction Control system expects the AS450 angle sensor to be mounted in the factory orientation inside the cab in the lower right rear corner.Note: Ensure that the sensor connector will be facing the rear of the machine.Global Navigation Satellite System Correction Data Radio
The GNSS correction data radio is necessary for the Landfill Compactors equipped with high accuracy option GNSS receivers on the Cat Compaction Control system to achieve a high accuracy fixed position. The system cannot enter an automatic control state unless the high accuracy option GNSS receivers achieve a high accuracy (Real-Time Kinematic Fixed) position.A GNSS correction data radio is not supplied with Cat Compaction Control system on the Landfill Compactors from the factory primarily due to the variety of supported radios and regional regulations surrounding such devices.
Illustration 8 g06163398
450MHz, 900MHz, or 2.4GHz SNRxxx Trimble radio
While there are various supported radio devices, two common GNSS Correction Data Radios are the SNRxxx Trimble radios and the Trimble SNM940 radio.The SNRxxx Trimble radio can be a 450MHz, 900MHz, or 2.4 GHz radio that communicates with a local base station radio for local GNSS corrections. The SNRxxx Trimble radio may connect to the Cat Compaction Control for the landfill system via J1939 CAN bus or the Ethernet. The Cat Compaction Control for the Landfill Compactors support a 26-pin connector on the Roll Over Protection (ROPS) structure on the right side of the machine. A radio bracket is a part of the Cat Compaction Control system. The assembly box structure for the receiver and the antenna on to top of the cab and the radio will be mounted