KNOB AS 2952275 - Caterpillar

Illustration 22 g00383677
Apply 4C-4030 Thread Lock Compound to the threads of socket head bolts (63). Install two limiter spacers (65), two limiter plates (64), and four socket head bolts (63) to swashplate (62). Tighten socket head bolts (63) to a torque of 34 3 N m (25.1 2.2 lb ft). Note: The bronze side of limiter plates (64) should face limiter spacers (65).
Illustration 23 g00380095
Illustration 24 g00383679
Install O-ring seal (60) on plug (59).
Install plug (59) in steering pump housing (3). Tighten plug (59) to a torque of 101.5 4.5 N m (74.86 3.3 lb ft).
Illustration 25 g00383752
Position O-ring seal (58) (not shown) on cover (57).
Position cover (57) on steering pump housing (3). Install three bolts (56). Tighten bolts (56) to a torque of 8.5 1 N m (6.27 0.74 lb ft).
Illustration 26 g00383815
Install shim pack (50) and bearing (48) on pump shaft (49).
Illustration 27 g00383816
If rod (39) was removed, install O-ring seal (46) on rod (39). If rod (38) was removed, install O-ring seal (45) on rod (38). Apply 4C-4030 Thread Lock Compound to the threads of rod (38) and rod (39). Install rod (38) and rod (39) in pump head (18). Tighten rod (38) and rod (39) to a torque of 79 4 N m (58.3 2.9 lb ft). Note: Refer to the note in Disassembly and Assembly, "Piston Pump (Steering) - Disassemble" for information on poppet (42) and seat (43).
Install bearing cup (47) in pump head (31).
Illustration 28 g00383819
Illustration 29 g00383892
Install pin (41) in pump head (31).
Install valve plate (40) on pump head (31). Be certain that the notch in valve plate (40) is aligned with pin (41).
Illustration 30 g00384073
Install piston (35) on rod (38). Install bias spring (36) and bias piston (37) on rod (39).
Illustration 31 g00384074
Install Tool (E) in steering pump housing (3). Install new gasket (34) on steering pump housing (3).
Illustration 32 g00384092
Illustration 33 g00378855
Use Tool (E) as a guide. Install pump head (31) on steering pump housing (3).
Install four socket head bolts (33) in steering pump housing (3). Hand tighten the four socket head bolts. Remove Tool (E) from steering pump housing (3).
Illustration 34 g00378648
Install two socket head bolts (32) in steering pump housing (3). Hand tighten the two socket head bolts. Tighten four socket head bolts (33) to a torque of 115 12 N m (84.8 8.9 lb ft). Tighten two socket head bolts (32) to a torque of 286 29 N m (210.9 21.4 lb ft). End By:
Install the pressure and flow compensator valve in the piston pump. Refer to Disassembly and Assembly, "Pressure and Flow Compensator Valve - Assemble" for the correct procedure.
Install the piston pump in the machine. Refer to Disassembly and Assembly, "Piston Pump (Steering) - Install" for the correct procedure.