LADDER AS 3382916 - Caterpillar

VIMSTM Router Configuration in VIMSpc
Reference: Special Instructions, REHS7342, "Procedure To Configure VIMS 3G On Certain Cat Products"Interface "Eth0.20"
Illustration 1 g03693644
"Eth0.20" screen
Interface "Eth0.20" is used for the following:
Cab connection
For internal machine communications
As a singular virtual network to handle the internal machine communicationsNote: Router configuration should only be set up when changing the ECM's IP address or when using an off-board radio.Interface "Eth0.1.0"
Illustration 2 g03693666
"Eth0.1.0" screen
Interface "Eth0.1.0" is for the future use of a Telematics Radio.Interface "Eth0.11"
Illustration 3 g03693671
"Eth0.11" screen
Interface "Eth0.11" is used for the Minestar/cell modem/site radio Ethernet connection.This port is:
Primarily configured as a default route when altering the IP address through Cat® Electronic Technician (Cat ET) or the route "webpage" tab.
The only IP address that is editable on the ECM.When this address is altered, a default route will be added that consists of a destination of "0.0.0.0" and a subnet of "0.0.0.0". All traffic that is not pre-configured through the internal route table (not visible/editable by user) will by default go through this route. The gateway is configured as the same address as the gateway of this port. The metric defaults to "29" and the port is also by default set to "eth0.1.0". More routes can be added but should not be necessary as VIMS is directing all unknown traffic to the gateway using the above route.