LADDER AS 5048544 - Caterpillar

Installation Procedure
Start By:
Raise the cab. Refer to Disassembly and Assembly, "Cab - Tilt".
Illustration 1 g00676608
Disconnect electrical connector (1) .
Remove grommet (2) .
Remove two nuts (3) and washers.
Illustration 2 g00676621
Remove three bolts (4) and access panel (5) .
Illustration 3 g00676662
Disengage cab support (6) and lower the cab.
Illustration 4 g00676676
Remove two nuts (7) and washers under the front of the seat.
Illustration 5 g00676681
Remove seat (8) .Note: For additional information concerning the seat, refer to Service Manual, SENR6615, "Contour Series Seat".Installation Procedure
Illustration 6 g00676681
Place seat (8) into position.
Illustration 7 g00676676
Install washers and two nuts (7) under the front of the seat. Tighten the nuts.
Illustration 8 g00676662
Raise the cab and engage the cab support (6) .
Illustration 9 g00676621
Install access panel (5) with three bolts (4). Tighten the bolts.
Illustration 10 g00676608
Install washers and two nuts (3) .
Install grommet (2) .
Connect electrical connector (1) .End By: Lower the cab. Refer to Disassembly and Assembly, "Cab - Tilt".