LADDER ASSEM. 6S4957 - Caterpillar

Quick Coupler Function (if Equipped)
Disengaging the coupler pins will release the work tool from control of the operator.Serious injury or death may result from disengaging the work tool when it is in an unstable position or carrying a load.Place the work tool in a safe position before disengaging the coupler pins.
Inspect the quick coupler engagement before operating the machine.Serious injury or death may result from improperly engaged coupler.
Crush injury. Could cause serious injury or death. Always confirm that the quick coupler is engaged onto the pins. Read the Operator's Manual.
If your machine is equipped with the Fusion coupler, refer to the Operation and Maintenance Manual for the "Fusion Quick Coupler" for detailed operation information.Coupling the Work Tool
Front Work Tool Coupler for Tools That Do Not Require Hydraulics
Position the bucket or the work tool on a level surface.
Press the quick coupler button on the keypad.
A message will come up on the display to select "Engage" or "Disengage" for the coupler.
Select the disengage option by toggling the quick coupler button or use the Four Way Navigation arrows on the display to select "Disengage".
Press and hold the quick coupler button for 2 seconds to activate cylinders or use the "OK" button on the display to activate the cylinders.
Tilt the coupler assembly forward.Make sure that the coupler assembly is below the level of the hooks on the work tool that will be attached.
Slowly, drive the machine forward. Align the hooks on the work tool with the coupler assembly.
Pull back on the lift lever in order to raise the coupler slightly. Raise the coupler until the coupler assembly contacts the hooks on the work tool and the work tool is lifted slightly.Make sure that the work tool is level from one side to the other side.
Tilt back the coupler assembly until the alignment bar of the work tool contacts the coupler.
Press the quick coupler button.
A message will come up on the display to select "Engage" or "Disengage" for the coupler.
Select the engage option by toggling the quick coupler button or use the Four Way Navigation arrows on the display to select "Engage".
Press and hold the quick coupler button for 2 seconds to activate cylinders or use the "OK" button on the display to activate the cylinders.Note: Visually ensure that both coupler pins are extending out of the holes in the work tool mounting bracket. Ensure that the tool is firmly attached and continue with steps 8 through 10.
Push the tilt lever in order to tilt the work tool downward.
Push the lift lever forward in order to put down pressure on the work tool.
Back up the machine and make sure that there is no movement between the work tool and the coupler.Steps 8 through 10 indicate that the coupler pins have fully engaged into the retainer holes for the work tool.Note: Operating instructions for specific work tools are not provided. The function of the control lever is dependent upon the installation of an Auxiliary Equipment Manufacturer work tool.Work Tools That Require Hydraulics
Follow the procedure