AVSPARE.COM
parts catalog

Lafayette 3606 Engine BBKYD00 - Caterpillar



BBKYD00 Lafayette 3606 Engine Caterpillar parts G3606B Lafayette
Rating:
13
Alternative (cross code) number:
CABBKYD00
BBK-YD00
BBKYD00
Caterpillar BBKYD00 Lafayette 3606 Engine

Buy Lafayette 3606 Engine BBKYD00 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE,

Compatible equipment models: BBKYD00:

GAS ENGINE  G3606B   Caterpillar
  For full view, you need register

Information:

Status Indicator Lights
Illustration 4 g03676187
Status indicators on the operator console
(26) Avoidance zone LED (not used)
(27) Parking brake LED
(28) Software stop LED
(29) Active fault LED
(30) Implement lockout LED
(31) Battery / antenna LED
"Avoidance Zone" (26) - For Future Use.
"Parking Brake" (27) - The parking brake is engaged.
"Software Stop" (28) - The machine is in an electronic stop safe state.
"Active Fault" (29) - There are one or more active faults.
"Implement Lockout" (30) - The implements are locked out (disabled).Active Fault Levels
During an active fault on the machine, the display will show the level of the machine fault. Refer to Table 2.To check the specific fault, perform the following:
The operator must lower implements to the ground.
Activate the implement lockout switch.
Set the parking brake.
Turn the machine OFF.
Check the information display inside the cab for additional information regarding the fault.Note: If possible park the machine on level ground.The following are examples of parameters that may cause an active fault. Active faults are not limited to these examples:
Engine Coolant Temperature
Torque Converter Temperature
Hydraulic Temperature
Fuel Level-Percent Remaining
Implement ECM State
Power train ECM State
Table 2
Parameter Active Fault LED State Description
"------" Off No Active Fault
"LVL1" Solid Yellow Level 1 Warning
"LVL2" Flashing Red Level 2 Warning
"LVL3" Flashing Red with Audible Alarm (1)(2) Level 3 Warning
(1) The machine comes to a stop and terminates the RC session when a level-3 event or diagnostic occurs. Can be overridden for 30 seconds at a time.
(2) Refer to Operation and Maintenance Manual, M0085769, "Machine Stopping" for regaining functionality on the Operator Console after a Software Stop (Safe Stop State) for a Level 3 stop.Indicator Lights Mounted on Machine
Illustration 5 g06264445
Rear view of the tractor
(2) RC mode indicators
Illustration 6 g06264452
Right-hand side RC mode indicator assembly
(3) Yellow indicator lamp (not used)
(4) Red indicator lamp
(5) Green indicator lamp
(6) Blue indicator lampThe Remote Control Indicators are used to alert the operator and other personnel of the machine working mode (Manual or Remote Control) and active stop conditions. The indicators may be concealed by enabling the Conceal Mode Switch. Alternatively, under special conditions, the Remote Control Indicators may be removed for special projects. Once the project has been completed, the Remote Control Indicators should be immediately returned to the machine.The lamps indicate the following:Yellow - Approaching Avoidance Zone (Not Used)Red - Active Stop IndicationGreen - Manual Mode or Manual Override ModeBlue - RC Status IndicatorThere are four different colored indicators located on-board the machine.The yellow indicator lamps are not used at this time.The red indicator lamp is used either when:
Avoidance Stop active (with avoidance installed)
Level 3 Event or Diagnostics
A Remote Shutdown is commanded
A Software Stop is active
An A-Stop is activeWhen a Remote Shutdown is commanded or a Software Stop is active, the Red indicator lamp flashes twice per second and the RC Status (Blue) indicator lamp is solid.The Green indicator lamp is on (solid) when the machine is either in manual mode or manual override mode and the cab key-switch is turned on.The blue indicator lamp is the RC status indicator. The RC status indicator is either ON or flashing in a heartbeat (double-beat) pattern.

Caterpillar SIS machinery equipment:



Parts lafayette Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.