AVSPARE.COM
parts catalog

Lafayette 3606 Engine BBRSK00 - Caterpillar



BBRSK00 Lafayette 3606 Engine Caterpillar parts G3606B Lafayette
Rating:
57
Alternative (cross code) number:
CABBRSK00
BBR-SK00
BBRSK00
Caterpillar BBRSK00 Lafayette 3606 Engine

Buy Lafayette 3606 Engine BBRSK00 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE,

Compatible equipment models: BBRSK00:

GAS ENGINE  G3606B   Caterpillar
  For full view, you need register

Information:


At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Close the jaws of the work tool. Place the work tool on the ground and shut off the engine on the host machine. Close the ball valves on the host machine in order to prevent excess oil to the work tool.
Inspect the area around the swivel for exterior leakage. If evidence of external leakage from the swivel is present, replace the seals in the swivel. Refer to Service Manual, "Swivel - Disassemble".
Illustration 1 g06320130
(1) Hose assembly for hydraulic cylinder
(2) Ball valve
Illustration 2 g06265207
(3) Cap
Disconnect two hydraulic hoses (1) from the cylinder. Install caps (3) onto the fittings of the cylinders and plug the hoses.
Disconnect hose assembly (1) from ball valve (2) on the stick. Place the open end of the hose in a suitable container.
Start the engine of the host machine and operate the machine until the hydraulic oil reaches normal operating temperature.
Open the ball valve (2) that is still connected to the work tool. Activate the control that opens the jaws. Observe the open end of hose. If there is flow through the hose, the seals of the swivel are faulty. Replace the seals in the swivel. Refer to Service Manual, "Swivel - Disassemble". If there was no flow through the swivel and no external leakage was present, the seals of the swivel do not need replaced.Note: If the cylinder cycle times were not within the specifications and the seals in the swivel are sealing properly, the cylinder may be leaking internally.
Reconnect hose assembly (1) to the ball valve (2).
Remove the plugs from the hoses and remove the caps (3) from the fittings on the cylinder. Reconnect the cylinder hoses (1) to the cylinder.
The air must be purged from the work tool before operation. Refer to Service Manual, "Hydraulic System Air - Purge" for the proper procedure.

Caterpillar SIS machinery equipment:



Parts lafayette Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.