AVSPARE.COM
parts catalog

Lafayette 3616 Engine BHRNQ00 - Caterpillar



BHRNQ00 Lafayette 3616 Engine Caterpillar parts G3616 Lafayette
Rating:
81
Alternative (cross code) number:
CABHRNQ00
BHR-NQ00
BHRNQ00
Caterpillar BHRNQ00 Lafayette 3616 Engine

Buy Lafayette 3616 Engine BHRNQ00 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE,

Compatible equipment models: BHRNQ00:

GAS ENGINE  G3616   Caterpillar
  For full view, you need register

Information:

Hydraulic System
Look at the Oil Level
Hot oil can cause burns.At operating temperature, the hydraulic tank is hot and under pressure.Remove the fill cap only when the engine is stopped, and the cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure.
Backhoe - Position the machine on level ground, with the stick and bucket cylinders fully extended and the boom lowered. Clamshell - Position the machine on level ground with the stick cylinder fully extended and the clamshell bucket open on the ground.1. Check the level with the hydraulic oil cold and the engine stopped.2. Open the front access door on the right side. 3. The oil level should be between the FULL and the ADD marks on the sight gauge. 4. If necessary to add oil, pull the latch and open the fill cap access door. 5. Remove the cap slowly to relieve pressure. Add oil to the correct level.6. Inspect the cap gasket. Replace it if it is damaged. Install the cap and close the access doors.Electric Air Compressor
Look at the Oil Level
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
1. Open the rear access door on the left side. 2. Maintain oil level to the top of the bottle (1).3. Add oil if necessary through top spout (2).4. Close the access door.Boom and Stick
Lubricate the Fittings
Lubricate four fittings on top side of boom. Lubricate two fittings at the head end of the boom cylinders. Lubricate one fitting on the rod end of the stick cylinder. Lubricate one boom bearing fitting. Lubricate two fittings on the stick.Backhoe Linkage
Lubricate the Fittings
Lubricate one fitting on the head end of the bucket cylinder. Lubricate four fittings on the power link and one on the rod end of the bucket cylinder.Swing Bearing
Lubricate the Fitting
Rotate the upper structure 720° (two full rotations). Stop at each 90° (1/4 turn) and lubricate the bearing through the fitting. Lubricate until grease can be seen flowing from behind the bearing seal.Air Conditioner (If Equipped)
Test Operation - Clean Filter
1. Start and run the engine at high idle. 2. Set the air conditioner controls on maximum and the fan on high.Allow two minutes for the system to stabilize.3. Turn the air conditioner off if poor cooling is experienced.4. Stop the engine. 5. Remove and clean the air conditioner filter.6. Wash it in clean warm water. Allow it to dry.7. Install the filter.8. If filter is not dirty, or if system does not operate properly after cleaning the filter, contact your Caterpillar dealer.

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts lafayette Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.