AVSPARE.COM
parts catalog

Lafayette 3606 Engine FYWMC00 - Caterpillar



FYWMC00 Lafayette 3606 Engine Caterpillar parts G3606B Lafayette
Rating:
83
Alternative (cross code) number:
CAFYWMC00
FYW-MC00
FYWMC00
Caterpillar FYWMC00 Lafayette 3606 Engine

Buy Lafayette 3606 Engine FYWMC00 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE,

Compatible equipment models: FYWMC00:

GAS ENGINE  G3606B   Caterpillar
  For full view, you need register

Information:

Caterpillar Machines So EquippedWhen hydraulic pumps are installed on Caterpillar machines, it is important not to force the pump into position. When input splines and pump shafts are out of alignment, stress loads are put on the internal components. This can cause pump failure.
Gear-type pumps that have had this type of problem will usually have a large groove worn into the brass pressure plate at the rear of the drive gear. Special Publication, "Diagnosing Tyrone Gear Pump Failures," Form FEG45137, has complete information on failures of this type. On a vane-type pump the shaft bearing will usually break if alignment is bad.
Make sure the pump housing flange fits evenly against the machined surface before the pump is fastened in position. Any debris or rough places between the pump flange and the machined surface must be removed.
Also, the pump housing must not come in contact with other components during operation.
If there has been a problem with pump failure on a machine, use the procedure which follows to see if wrong installation of the pump is the cause.
1. Check the end of the pump shaft. A shiny area on the end of the shaft is an indication the pump shaft is not in full alignment with the drive splines.2. If the splines on the end of the pump shaft are too short or not machined correctly, do not install the pump. Check the part number of the pump to be sure you have the correct pump.3. If there is a shoulder or step between the spline and the seal surface on the pump shaft, make sure the shoulder does not prevent a correct fit between the pump drive and the pump shaft.4. If you have any questions about how parts are to be machined or dimensions of parts, your Product Analyst in Service Engineering.

Caterpillar SIS machinery equipment:



Parts lafayette Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.