AVSPARE.COM
parts catalog

LAMP-HEAD 0003548 - Caterpillar



0003548 LAMP-HEAD Caterpillar parts LAMP
Rating:
11
Alternative (cross code) number:
CA0003548
000-3548
0003548
Caterpillar 0003548 LAMP-HEAD

Buy LAMP-HEAD 0003548 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Sudden movement of the machine or release of oil under pressure can cause injury to persons on or near the machine.To prevent possible injury, perform the procedure that follows before testing and adjusting the power train.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
If the engine is still running, stop the engine.
Exit the machine.
Illustration 1 g01012088
Remove cap (1) from charge relief valve (2) .
Illustration 2 g01012090
Loosen locknut (3) .
Turn adjustment screw (4) in order to adjust the relief pressure. Turn the adjustment screw counterclockwise in order to decrease the pressure. Turn the adjustment screw clockwise in order to increase the pressure.Note: One full turn is equal to approximately 380 kPa (55 psi).Note: When you adjust the charge relief valve in order to decrease the pressure, turn the adjustment screw for an additional one quarter turn past the estimated adjustment setting. Then, turn the adjustment screw clockwise for one quarter turn.
Maintain the position of the adjustment screw as you tighten the locknut.
Perform the test for the charge relief valve. Refer to Testing and Adjusting, "Initial Pressure Test".
Repeat Step 3 through Step 7 until the charge relief valve is set to the correct specification.
Illustration 3 g01012088
Install a new cap (1) onto charge relief valve (2) .


Parts lamp Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.