LAMP GP-FLOOD 2344327 - Caterpillar

Note: Use the diagnostic feature on the P808 interface in order to troubleshoot. Refer to the "P808 For Windows" software manual for instructions. The interface will display the state of the module, any alarm conditions that are present, and the state of all the inputs and the outputs. The diagnostic interface should be used to troubleshoot when it is possible.
Personal injury or death can result from high voltage.When power generation equipment must be in operation to make tests and/or adjustments, high voltage and current are present.Improper test equipment can fail and present a high voltage shock hazard to its user.Make sure the testing equipment is designed for and correctly operated for high voltage and current tests being made.When servicing or repairing electric power generation equipment:
Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE.
Remove all fuses.
Make sure the generator engine is stopped.
Make sure all batteries are disconnected.
Make sure all capacitors are discharged.Failure to do so could result in personal injury or death. Make sure residual voltage in the rotor, stator and the generator is discharged.
When the engine-generator, or any source to which the engine-generator is synchronized to, is operating, voltages up to 600V are present in the control panel.Do not short these terminal with line voltage to ground with any part of the body or any conductive material. Loss of life or injury could result from electrical shock or injury from molten metal.
Do not connect generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure main distribution system switch, or if the connection is permanent, install a double throw transfer switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility as to the applicable circumstances.
Illustration 1 g00837735
520 Control Module (Generator Set) (1) Indicator for oil pressure (2) Indicator for alarm (3) Indicator for coolant temperature (4) Automatic start position (5) Indicator for engine overcrank
Table 1
Symptom     Possible Remedy    
Unit does not operate     Select AUTO (4) on the control module. Check the battery and check the wiring to the unit. Check the DC power supply. Check the fuse for the DC power supply.    
Unit shuts down     The DC power supply voltage should be between 8 VDC and 35 VDC. Check that the operating temperature is below
55 °C (131 °F). Check the fuse to the DC power supply.    
Unit locks out on Emergency Stop     If an emergency stop switch is not configured, connect the emergency stop input to the positive terminal of the DC power supply. Check that the emergency stop switch is functioning correctly. Check for an open circuit.    
Intermittent sensor fault     Ensure the ground shield for the engine speed sensor is connected at one