LAMP GP-HEAD & SIGNAL 2526643 - Caterpillar

Illustration 1 g01051091
Rotate the switch on the Parallel Cabinet Interface Board to the corresponding Multiple Module Unit.Proceed to Step 6.
Illustration 2 g00839256
Illustration 3 g00840027
Remove all sheet metal panels. Remove the sheet metal panel for the System I/O and Isolation Board (2).
Connect a PC to the System RS232/RS485 port that is located on the System I/O and Isolation Board. Make sure that jumper Jmp1 (3) on the System I/O and Isolation Board is in the correct position.Note: The lower side is RS232 and the higher side is RS485.
Start your Personal Computer.
Illustration 4 g00840053
(4) CAT UPS View Icon
Run UPS View by double clicking over the icon (4) on your PC.
Illustration 5 g01003395
Illustration 6 g01003391
Click over the "Settings" (7) in the menu bar.The "Connection" window that is shown in illustration 5 will open.
Click on the radio button that has the label "Direct Connect (serial)" (6) .
Select your PC COM Port for this Serial Connection and set the Baud rate.The radio button for "Detailed MMU Telemetry" (5) must be checked.Note: The default baud rate is 38400.
Click on "OK" Button (10) in order to accept these settings.
Illustration 7 g01003435
Click on "Connection" on the menu bar.
Select "Connect" from the drop-down menu.You will be connected to the system and you will receive the system Telemetry.
Illustration 8 g01003470
Once you are Connected, Click over the "Enter Password" (13) in the menu bar.The window that is shown in illustration 8 will appear.
Enter "User Name" and enter "Password".
Click on "OK" Button.After the Password has been entered, the Menu Option will Change.The menu bar will contain a "Calibrate" Option.
Click on "Calibrate".
Select "Field Coil Current".You will hear input contactor "K1" close. The Static Switch will turn on. The DC Bus will rise. A "Calibration of a Channel" window will open.
Click on "View Status" button.Another "Calibration Status" window will open.If the window that opens in Step 19 blocks your view of "Calibration of a Channel" window, drag the window aside.
Click on "Use Defaults" that is located on "Calibration of a Channel" window.You will be prompted to "Enter Calibration Point" for "Top Field Coil Current".
The "Minimum" button on "Calibration of a Channel" window is default selection.
Clamp the DC Current probe around the conductor on the positive terminal for the Top Field Coil in order to take a reading. Leave the DC current probe that is hanging on this conductor for the next reading. This