LANYARD 4557868 - Caterpillar

Table 1
Customer Specified Parameters    
ECM Parameter    Possible Values    Default Value    
ECM Identification Parameter    
Equipment ID     17 Digits
Available characters are dependent on the service tool that is used     Not Programmed    
Engine Rating Parameter    
Rating Number     1 to 7     1    
Engine Idle Shutdown    
Minimum Ambient Air Temperature     0 to 29 degrees C     0 degrees C    
Maximum Ambient Air Temperature     30 to 100 degrees C     30 degrees C    
Shutdown Enable Status     Disabled
Enabled     Disabled    
Shutdown Delay Time     1 to 60 minutes     5 minutes    
Ambient Temperature Override Enable Status     Disabled
Enabled     Disabled    
Multiple Engines on J1939    
Engine Location     Engine #1
Engine #2
Engine #3
Engine #4
Engine #5     Engine #1    
Miscellaneous    
Monitoring Mode Shutdowns     Disabled
Enable     Enabled    
Monitoring Mode Derates     Disabled
Enabled     Enabled    
Engine Acceleration Rate     0 to 65503 rpm/sec     0 rpm/sec    
Engine Speed Deceleration Ramp Rate     0 to 65503 rpm/sec     0 rpm/sec    
Configurable Inputs    
Coolant Level Switch     Not Installed
Installed     Not Installed    
Oil Level Switch     Not Installed
Installed     Not Installed    
Air Filter Restriction Switch Installation Status     Not Installed
Installed     Not Installed    
Air Filter Restriction Switch Configuration     Normally Open
Normally Closed     Normally Open    
User Defined Switch Installation Status     Not Installed
Installed     Installed    
Auxiliary Temperature Sensor Installation Status     Installed
Not Installed     Not Installed    
Auxiliary Pressure Sensor Installation Status     Installed
Not Installed     Not Installed    
Fuel Filter Differential Pressure Switch Configuration     Not Installed
Normally Open
Normally Closed     Not Installed    
J1939 Continuous Fault Handling    
Remote Torque Speed Control Enable Status     Enabled
Disabled     Disabled    
System Settings    
System Operating Voltage Configuration     12 VDC
24 VDC     Customer Option    
Passwords    
Customer Password 1     Eight alphanumeric characters     Eight spaces    
Customer Password 2     Eight alphanumeric characters     Eight spaces    
Security Access Parameters    
CAN Communication Protocol Write Security     Seed and Key
No Security     Seed and Key    
CAN Communication Protocol Read Security     Seed and Key
No Security     Seed and Key