LATCH AS 2920450 - Caterpillar

Illustration 5 g02723360
Disconnect clips (7) .
Illustration 6 g02723363
Disconnect harness assembly (8) . Disconnect clips (9) .
Illustration 7 g02723367
Remove bolts (10) . Position control module (11) out of the way.
Illustration 8 g02723371
Disconnect tube (12) . Remove the connecting hardware and pull the tube through the rear chassis support.
Illustration 9 g02723518
Disconnect harness assembly (13) and remove the connecting hardware.
Illustration 10 g02723524
Disconnect clip (14) . Disconnect cable assembly (15) .
Illustration 11 g02723527
Disconnect clip (16) . Disconnect cable assembly (17) .
Illustration 12 g02723532
Disconnect tubes (18) and reposition out of the way. Disconnect clips (19) .
Illustration 13 g02723644
Remove clip (20) . Disconnect harness assembly (21) . Remove tube (22) .
Illustration 14 g02723623
Disconnect hose (23) . Pull the hose from the rear chassis support.
Illustration 15 g02723651
Disconnect clamps (24) . Remove exhaust tube assembly (25) .
Illustration 16 g02723667
Disconnect harness assembly (26) and remove the connecting hardware.
Illustration 17 g02723713
Disconnect hose assemblies (27) . Remove clip (28) .
Illustration 18 g02723677
Illustration 19 g02723685
Attach Tooling (A) and a suitable lifting device onto both sides of engine enclosure (29) .
Remove bolts (30) . Repeat this step for the opposite site of the engine enclosure.
Use Tooling (A) and the suitable lifting device to remove engine enclosure (29) . The weight of engine enclosure (29) is approximately 500 kg (1102 lb).Installation Procedure
Install the engine enclosure (29) in the reverse order of removal.
Tighten clamps (24) to a torque of 35 2 N m (26 2 lb ft).Note: Tighten clamps (24) with 75 rpm maximum air wrench.