LATCH AS 3163436 - Caterpillar

Installation Procedure (Out of Chassis)
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     1    
Illustration 15 g01024183
Install Tooling (A) and a suitable lifting device to control valve (16). Install control valve (16) in case assembly (13). The weight of control valve (16) is approximately 36 kg (80 lb).
Install bolts (22) and washers in control valve (16). Tighten bolts (22) to a torque of 48 4 N m (35 3 lb ft).
Illustration 16 g00591200
Install O-ring seals (21) on sleeve (20) .
Illustration 17 g00591199
Install bolt (19) in control valve (16). Install sleeves (20) .
Illustration 18 g00591197
Install new locking bolt (18) and washer (17) in control valve (16) .
Illustration 19 g00591196
Install O-ring seal (15) on harness assembly (4) .
Illustration 20 g00591189
Install cover gasket (14) on case assembly (13) .
Illustration 21 g00591187
Install cover (11) on case assembly (13). Install bolts (12) in order to secure cover (11) to case assembly (13). Install plate (10) on cover (11). Install bolts (9) in order to secure plate (10) to cover (11) .
Illustration 22 g00591186
Install gasket (8) .
Illustration 23 g00591185
Install retainer (7), as shown. Make sure that harness assembly (4) is positioned, as shown. Install two bolts (6) and washers in order to secure retainer (7).
Illustration 24 g00591183
Install nut (5) on harness assembly (4). Tighten nut (5) to a torque of 9 1 N m (80 9 lb in).
Illustration 25 g00591182
Install O-ring seals (3) on manifold (1) .
Illustration 26 g00591181
Install manifold (1). Install bolts (2) and the washers in manifold (1).