LATCH (R.H.) 9D5194 - Caterpillar

Engine3512E (S/N: MR21-UP; SY21-UP; MD31-UP; MR31-UP; SY31-UP; MR41-UP; SY41-UP; SY51-UP; SY61-UP; MR71-UP; SY71-UP; MR81-UP; SY81-UP; SY91-UP)3516C (S/N: TKG1-UP; TKJ1-UP; TKK1-UP)3516E (S/N: SW21-UP; SW31-UP; SW41-UP; MD51-UP; SW51-UP; SW61-UP; MR91-UP; MRC1-UP; SWD1-UP; SWK1-UP; MRN1-UP; MRY1-UP)C175-16 (S/N: P6N1-UP; P6P1-UP)C280-08 (S/N: J4R1-UP)C280-16 (S/N: 3N31-UP; A4F1-UP; R4M1-UP; S4M1-UP)Marine EngineC280-12 (S/N: RA41-UP; RH71-UP)C32 MARINE (S/N: MX41-UP; PWT1-UP)C32 MARINE GS (S/N: MG41-UP)Retrofit AftertreatmentSCR (S/N: EF51-UP; EH61-UP; EH71-UP; EH81-UP; EH91-UP)Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Safety Section
Personal injury or death can result from high voltage.Moisture could create paths of electrical conductivity.Make sure the unit is off line (disconnected from utility and/or other generators), locked out and tagged "Do Not Operate".
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Failure to follow all safety guidelines prescribed in this document and by governing authorities and regulatory agencies may result in severe injury or death of personnel or machine damage.
When removing a major component or attachment, ensure that it is properly blocked or secured before removing mounting hardware. An assembly that is disconnected without proper blocking may shift or fall, resulting in serious injury or death of personnel or machine damage.
Personal injury or death can result from improper maintenance procedures. To avoid injury or death, follow the procedures exactly as stated below.
Personal injury can result from improper handling of chemicals.Make sure you use all the necessary protective equipment required to do the job.Make sure that you read and understand all directions and hazards described on the labels and material safety data sheet of any chemical that is used.Observe all safety precautions recommended by the chemical manufacturer for handling, storage, and disposal of chemicals.
Before servicing/performing maintenance on the machine, electrical power must be physically disconnected; battery plugs must be disconnected from the batteries, or the trailing cable must be unplugged, and warning tags and padlocks shall be applied by a certified electrician. Certified electricians shall perform or direct any electrical work, including any energized testing, repair work in controllers, motors, or other approved compartments, and shall insure that all compartments are properly closed and inspected prior to re-energization. All applicable lock out and tag out procedures must be followed.
Observe the safe working load limits of all lifting and blocking devices and keep a safe distance from suspended/b