LEAD ASSEM. 2P5651 - Caterpillar

Electric Power Generation: AllMachine Control and Guidance Products: PRODUCT LINK (S/N: PL61-UP)Introduction
This Special Instruction outlines the procedure for installing Continuous Telematics Power Retrofit (CTPR) which is a retrofit option that can be installed on an asset to provide continuous reporting from the Product Link system regardless of the state of the master disconnect switch of the asset.When the master disconnect switch of the asset is turned OFF (opened), all power is removed from the Product Link system. On a standard Product Link installation this action will completely disable the device, so the device can no longer determine asset location or communicate with Product Link Web.To allow the Pro and Elite systems to continue reporting when the master disconnect switch of the asset is turned OFF (opened), the Continuous Telematics Power Retrofit option can be installed. This retrofit option involves bypassing the master disconnect switch of the generator set package to provide continuous power to the Product Link system.Do not perform any procedure in this Special Instruction until you have read this entire Special Instruction and you understand this informationNote: This procedure applies only to the Product Link Pro (PL641/PL631) and Elite (PLE641/PLE631) systems. Caterpillar is not responsible for data loss, damage to the Product Link, or damage to the generator set package if this procedure is used with any Product Link System other than the Pro and Elite systems.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person must also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons.Caterpillar cannot anticipate every possible circumstance of a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Avoid using a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar. If used, ensure the safety of the operating personnel and others.Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Required