LEVER 1216607 - Caterpillar

Removal Procedure
Start By:
Install the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Remove the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Remove and Install".Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help prevent dirt from entering the internal mechanism.Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Drain the hydraulic tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the proper draining procedure.
Illustration 1 g01091484
Disconnect hose assemblies (2) and (4) .
Disconnect the hose assembly from fitting (5). Remove fitting (5) .
Disconnect tube assembly (3) .
Remove the two bolts that hold shield (1). Remove shield (1) .
Illustration 2 g01091483
Loosen two clamps (6). Remove two bolts (7) .
Remove tube assembly (3) .
Illustration 3 g01091737
Attach a suitable lifting device to vane pump (10). The weight of vane pump (10) is approximately 59 kg (130 lb).
Remove two bolts (12) .
Remove vane pump (10) .
Remove the four bolts that hold adapter (8). Remove adapter (8) and the O-ring seal.
Remove four bolts (11) and elbow (9) .
Remove the O-ring seal from elbow (9) .
Illustration 4 g01091738
Remove O-ring seal (12) .