LEVER A. 1M0224 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Raise the engine hood.
Illustration 1 g01168148
Remove panel (1) .
Illustration 2 g01168246
Use knob (4) to drain the fuel into a suitable container for storage or disposal.
Disconnect harness assembly (5) .
Disconnect hose (6) and hose assemblies (7) .
Remove bowl assembly (9) .
Use Tooling (A) to remove primary fuel filter (8) .
Remove bolts (2) and fuel priming pump (3) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01168246
Position fuel priming pump (3) and install bolts (2) .
Use Tooling (A) to install primary fuel filter (8) .
Install bowl assembly (9) .
Connect hose (6) and hose assemblies (7) .
Connect harness assembly (5) .
Make sure that knob (4) is in the CLOSED position.
Illustration 4 g01168148
Install panel (1) .
Close the engine hood.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".