LEVER AS-TILT 2333597 - Caterpillar

Removal Procedure
Start By:
Remove the flywheel.
Illustration 1 g01132235
Remove bolts (1).
Remove crankshaft rear seal (2) and the O-ring seal. Note: Refer to Reuse and Salvage Guidelines, SEBF8039, "Crankshaft Visual Inspection and Magnetic Particle Inspection" for the correct inspection procedure of the crankshaft seal surface.Note: Refer to Reuse and Salvage Guidelines, SEBF9217, "Specifications for Crankshafts C7, C9, C-9, C10, C11, C12, C-12, C13, C-13, C15, C-15, C18, C-18, C27, C30, and C32 Engines" or the correct specifications of the crankshaft.Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 7649 Primer N -
B - Loctite 620 Retaining Compound -
C 147-2675 Wear Sleeve Installer 1 Note: Leave the shipping sleeve in place in order to install the crankshaft rear seal. The crankshaft rear seal must be installed dry.
Illustration 2 g01140085
Illustration 3 g03698745
Numerical tightening sequence for bolts (2).
Note: If required, install a crankshaft wear sleeve at engine overhaul. For more information please refer to the following Reuse and Salvage Guidelines. Refer to Reuse and Salvage Guidelines, SEBF9217, "Specifications for Crankshafts C7, C9, C-9, C10, C11, C12, C-12, C13, C-13, C15, C-15, C18, C-18, C27, C30, and C32 Engines" or the correct specifications of the crankshaft. Refer to Reuse and Salvage Guidelines, SEBF8039, "Crankshaft Visual Inspection and Magnetic Particle Inspection" for the correct inspection procedure of the crankshaft seal surface.
If a crankshaft wear sleeve is necessary, refer to Step 1.a through Step 1.d to install the crankshaft wear sleeve. If a crankshaft wear sleeve is not necessary, refer to Step 2.
Clean and polish the crankshaft of imperfections.
Use Tooling (A) to clean the outside diameter of the crankshaft and the inside diameter of the crankshaft wear sleeve.
Apply Tooling (B) to the outside diameter of the crankshaft and the inside diameter of the crankshaft wear sleeve.
Use Tooling (C) to install the crankshaft wear sleeve. Note: Leave the shipping sleeve in place to install the crankshaft rear seal. The crankshaft rear seal must be installed dry.Note: If the seal group, O-ring seal, and the shipping sleeve are separated, these components should not be used.
Lubricate the O-ring seal with clean engine oil that is on the back of the crankshaft rear seal (1).
Position crankshaft rear seal (1) and the shipping sleeve over the crankshaft. Push crankshaft rear seal (1) in place to dislodge the shipping sleeve. Note: Do not remove the shipping sleeve until bolts (2) are installed.
Install new bolts (2) hand tight. Then, tighten bolts (2) in numerical sequence, shown in Illustration 3. Tighten bolts (2) to a torque of 12 3 N m (106 27 lb in). End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".