LEVER-GOVERNOR OUTPUT 2W0581 - Caterpillar

2W0581 LEVER-GOVERNOR OUTPUT Caterpillar parts G3408, G3412

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2W0581
2W-0581
2W0581

Caterpillar 2W0581 LEVER-GOVERNOR OUTPUT

Weight: 0.50 pounds 0 kg.

Information:

ARM OFFSET DIMENSION 28.65 mm

AXIS CENTERLINE TO CENTERLINE DIMENSION 146.05 mm

AXIS OFFSET DIMENSION 0 mm

FULCRUM HOLE DIAMETER 9.5 mm

LINKAGE HOLE DIAMETER 7.5 mm

Buy LEVER-GOVERNOR OUTPUT 2W0581 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE,

Compatible equipment models: 2W0581:

GAS ENGINE G3408 G3412 Caterpillar

Number on catalog scheme: 2

Caterpillar 2W0581 Parts scheme LEVER-GOVERNOR OUTPUT

For full view, you need register

Information:

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that all components are clean and free from wear and damage. Refer to Specifications, "Rocker Shaft" for more information. If necessary, replace any components that are worn or damaged.
Illustration 1 g03454396
If necessary, follow Step 2.a in order to install threaded inserts (1) to the rocker arms.
Loosely install threaded inserts (1) to rocker arm assembly (4) and rocker arm assembly (5). Note: The components must be reinstalled in the original location. Do not interchange components.
Lubricate the bore of rocker arm assemblies (4) for the inlet valve with clean engine oil.
Lubricate the bore of rocker arm assemblies (5) for the exhaust valve with clean engine oil.
Lubricate rocker shaft (6) with clean engine oil.
If necessary, install retaining clip (2) and spring (3) to the front end of rocker shaft (6).
Install rocker arm assembly (4) for number one inlet valve to the rocker shaft. Install rocker arm assembly (5) for number one exhaust valve to rocker shaft (6). Note: The rocker arm assembly for the inlet valve is longer than the rocker arm assembly for the exhaust valve. Used components should be installed in the original location.
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install retaining clip (7) to rocker shaft (6).
Install spring (8) to rocker shaft (6).
Install rocker arm assembly (4) for number two inlet valve to the rocker shaft. Install rocker arm assembly (5) for number two exhaust valve to rocker shaft (7). Note: The rocker arm assembly for the inlet valve is longer than the rocker arm assembly for the exhaust valve. Used components should be installed in the original location.
Repeat Step 8 through Step 10 in order to assemble the remaining components to rocker shaft (6). End By:
Install the rocker shaft assembly. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install" for the correct procedure.