LEVER 3P8040 - Caterpillar

Illustration 1 g01450344
Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall. Replace the illustrations if the illustrations are not legible. Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part.Alternate Exit (1)This message is located on the right side window.
Illustration 2 g01002993
Unlock the alternate exit during machine operation.ROPS (2)This message is located on the left side of the cab below the recessed grab handle.
Illustration 3 g01212169
ReferenceFor information, refer to Operation and Maintenance Manual, "Guards (Operator Protection)".Product Link (3)
Illustration 4 g01418953
This film informs the user that "Product Link" is protected by Data Privacy. See Operation and Maintenance Manual, "Product Link" for more information.Air Conditioner (4)This message is located in two places. One location is inside the cab on the lower left face of the operator seat. Also, this message is also located next to the service information number plate.
Illustration 5 g00983944
ReferenceFor information on the cooling system, refer to Special Publication, SEBU6250, "Caterpillar Machine Lubricant Recommendations".Your Caterpillar dealer has the trained personnel and the correct tools for this procedure.No Step (5)This message is located on each of the striker bars except for the rear two striker bars.
Illustration 6 g00906093