LEVER ASSEM. 4K8559 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Start the engine. Lower the screed onto a flat, level surface. Null the screed to the flat surface. Stop the engine.
Illustration 1 g01303243
Disconnect harness assembly (1) .
Illustration 2 g01303244
Disconnect hose couplers (2). Install the protective cap.
Illustration 3 g01303246
Remove bolts (3) .
Remove the screed.Installation Procedure
Install the screed.
Illustration 4 g01303246
Install bolts (3) .
Illustration 5 g01303244
Connect hose couplers (2) .
Illustration 6 g01303243
Connect harness assembly (1) .