LEVER 4L4470 - Caterpillar

4L4470 LEVER Caterpillar parts D343

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4L4470
4L-4470
4L4470

Weight: 0.50 pounds 0 kg.

Information:

ARM OFFSET DIMENSION 10.32 mm

AXIS CENTERLINE TO CENTERLINE DIMENSION 86.36 mm

AXIS OFFSET DIMENSION 0 mm

FULCRUM HOLE DIAMETER 19.05 mm

LINKAGE HOLE DIAMETER 9.525 mm

Buy LEVER 4L4470 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE,

Compatible equipment models: 4L4470:

INDUSTRIAL ENGINE D343 Caterpillar

Number on catalog scheme:

For full view, you need register

Information:

Illustration 1 g06133896
Implement ECM Calibration screen
To access the calibration procedures for the Implement ECM, establish the connections of the Cat ET to the machine. Navigate to the calibration screen by clicking "Service" on the tool bar and then clicking "Calibrations". Click on the calibration that is needed.Once the specific calibration is selected, the Cat ET will guide you through the calibration procedure.The Cat ET will list initial machine conditions that must be satisfied before the ECM will allow the calibration procedure to continue. Follow the specific instructions on the display in order to complete the calibration procedure.Note: The "CALIBRATION REQUIRED" diagnostic will be active and the ECM will revert to the previous successful calibrated values if a calibration is aborted at any time. In order to clear the diagnostic, cycle the key.The following list details the calibrations that can be performed for the components on the Implement ECM.
Lever Calibrations
Linkage Sensor Calibration
Pump Calibrations
Implement Valve Calibrations
Payload Control System Calibrations