LEVER 5T0013 - Caterpillar

START BY:a. remove camshaftb. remove flywheel housingc. remove pistonsInstall Camshaft Bearings
1. Remove the rear camshaft bearing with tooling (A).2. Remove the remainder of the camshaft bearings with tooling (A). Start at the rear of the engine block and move toward the front.1. Use tooling (A) to install the camshaft bearings in the cylinder block starting with the rear bearings (see illustration B71294X2 for the correct dimensions)2. All camshaft bearings must be installed so that the holes in the bearings are 90 15° from the oil holes in the cylinder block.3. After assembly the inside diameter of bearings (1) must be 69.969 0.048 mm (2.7500 .0019 in.). The remainder of the bearings must have an inside diameter of 69.982 0.061 mm (2.7552 .0024 in.).END BY:a. install camshaftb. install pistonsc. install flywheel housing