LEVER 5T5338 - Caterpillar

Illustration 10 g03828607
(1) 471-8263 Support As (2) 471-8264 Clamp As (5) 124-7346 Lockwasher (9) 8T-4137 Bolt (12) 9X-2027 Washer
Pre-assemble 471-8263 Support As (1 ) with 471-8264 Clamp As (2), using one 124-7346 Lockwasher (5), one 9X-2027 Washer (12), and one 8T-4137 Bolt (9) .
Illustration 11 g03828645
(1) 471-8263 Support As (2) 471-8264 Clamp As (3) 471-8267 Position Sensor (8) 8T-0389 Locknut (10) 8T-4185 Bolt (12) 9X-2027 Washer
Assemble 471-8267 Position Sensor (3) into 471-8264 Clamp As (2) previously installed on support (1) using one 8T-4185 Bolt (10), one 9X-2027 Washer (12), and one 8T-0389 Locknut (8) .
Illustration 12 g03828671
Assemble the sonic sensor pre-assembly (A) onto 481-2984 Support (4) using one 8T-4137 Bolt (9) .
Assemble 481-2984 Support (4) to the screed end gate using the existing threaded holes using two 8T-4192 Bolts (11), and two 5P-8245 Hard Washers (6) .Note: If you have a machine with an S/N below S/N:D8A286 refer to Step 5, if not continue to Step 6.
Illustration 13 g03828703
(4) 481-2984 Support
The removal of the end-gate plate circled in Illustration 13 must be done before assembling the 481-2984 support (4) onto the screed end gate.
Illustration 14 g03828724
(B) Machine connection (13) 471-8269 Control Cable Gp
Assemble 471-8269 Control Cable Gp (13) on the connector present on the rear wall of the machine frame (B) to the connection on the 471-8267 Position Sensor (3) .
Repeat Steps 1 through Step 7 to complete the second sensor.