LEVER AS 5V8783 - Caterpillar

Illustration 8 g03764407
View of "Config #7" menu
"Extinguish Spray Config 7 Set" has been added to "Config #7". This setting allows the configuration to be set to a constant spray volume regardless of ground speed. This setting will work well when using the truck in fire-fighting situations at low speed, stopped, or in reverse. An upper deactivation can be set to ensure that this functionality is not used for normal mine site operation.
Illustration 9 g03764409
View of "Units" display
"Tank Lift" above "F4" will only be present when all the interlocks are met for this option.
Illustration 10 g03764412
View of "Tank Lift Page" display
"Tank Lift" now has a "Boost" function to increase lifting power for hard to lift tanks.
"Lift Tank" and "Lower Tank" are the only functions that can be used with "Boost".
"Lift Tank" and "Lower Tank" functions operate with default current when used without "Boost".
When "Boost" is pressed simultaneously with either "Lift Tank" or "Lower Tank" function, the current will rise. When "Boost" is released, the current slowly returns to default.
After the tank is raised using "Boost" and "Lift Tank", tank will hold when only "Lift Tank" is released.
Illustration 11 g03764416
View of "Set Up" menu
Pin Codes can now be set for: "Set Up", "Config", "Manual", "Intermittent", and "System Override" functions.
Illustration 12 g03764417
View of "Diagnostics Status" display
Diagnostics have been added to detect "Water On/Off Switch Over Cycle".User Interface Improvements
Illustration 13 g03764418
View of "Adjust" menu
Illustration 14 g03764419
View of "System Overrides" menu
"System Overrides" menu has been added. This option will allow the truck to stay in production, at a reduced performance level, in the event of a WDS pressure sensor failure.
"Engine Mode" has been removed from the software. The system operates in full pressure mode.
Illustration 15 g03764420
View of "Diagnostics Status" display
The new WDS diagnostic strategy ensures that the operator or service technician can verify the type of fault that has occurred. The system and sensor diagnostics have been programmed to stay on until cleared by the operator or service personnel. An active fault will not clear. All diagnostics are logged, even if cleared.
Press "F1" to clear non-active diagnostics.
Press "F3" to reset "High Hydraulic Oil Temp" fault, after oil has cooled.
Illustration 16 g03764421
View of keypad (A) Tank fill button (B) Keypad
The "F1 Tank Level " display has been removed. "Tank Fill" display appears when "Tank Fill" button (A) on keypad (B) is pressed.
Illustration 17 g03764422
View of "Tank Fill" displayProgram Improvements
Improvements have been made for the system to resist false diagnostics, from hydraulic oil pressure fault, when engine is off.
The system now includes diagnostics to indicate WDS information link malfunctions.
The diagnostic log has been improved to continuously record faults, while discharging the oldest results.
Improvements have been made in maintaining "Tank Fill " actuation signal.
Intermittent distance settings have been calibrated to more accurately reflect the distance on the display.
Intermittent time and distance settings now have a larger adjustable range with more resolution.
Improvements have been made to allow "Manual Mode" to be activated at zero ground speed.
To avoid over-watering when the truck comes to a stop in the "Manual" mode, the water pump is deactivated when the spray