LEVER AS - 5Y1193 - Caterpillar

Which Generate This Code:The Electronic Control Module (ECM) detects one of the following conditions:
One or more of the programmable parameters has not been programmed.
One or more of the injector trim files are not programmed.System Response:The diagnostic code will only be active. The check engine lamp is illuminated while this diagnostic code is active.
Engine performance may be affected by unprogrammed parameters. The unprogrammed parameters determine the action that is taken by the ECM. The ECM may use a default torque map or the ECM may limit the engine to low idle.Test Step 1. Check the Programmable ParametersProgram the missing parameters, if necessary. Refer to Troubleshooting, "System Configuration Parameters".Load any missing injector trim files, if necessary. Refer to programming parameters Troubleshooting, "Injector Trim File".Results:
OK - The problem is resolved.STOP