LEVER AS 6L5284 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
ZZ 6V-9507 Face Seal Plug 2
6V-9828 Cap As 2
6V-9511 Plug 2
6V-9832 Cap As 2
9U-7092 Tapered Cap/Plug 2 Start By:
Release the hydraulic system pressure.
Drain the hydraulic oil.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01016784
Disconnect hose assembly (1), hose assembly (4) and hose assembly (3). Remove tube assembly (5). Remove bolts (6) from the manifold (2).
Position the manifold (2) out of the way.
Illustration 2 g01016789
Attach a suitable lifting device, as shown. Disconnect hose assembly (7). Remove bolts (8) and remove piston pump (saw) (9). The weight of the piston pump (saw) is approximately 40 kg (90 lb). Installation Procedure
Install piston pump (saw) (9) in the reverse order of removal.