LEVER 7N5360 - Caterpillar

Use a suitable press and Tooling (B) in order to remove bearing cone (21) from pump shaft (18).
Illustration 15 g00714348
Remove swashplate (22) from barrel assembly (23).
Illustration 16 g00714349
Remove piston assembly (24) from barrel assembly (23).
Illustration 17 g00714389
Remove piston assemblies (24) from retaining plate (25), as shown.
Illustration 18 g00714391
Remove retaining ball (26) from barrel assembly (23).
Illustration 19 g00714393
Illustration 20 g01121546
Illustration 21 g00714395
Sudden release of spring force can cause injury.To prevent the possibility of injury, follow the procedure to relieve the spring pressure.
Install Tooling (C), as shown.Note: There is spring force against retaining ring (27). When retaining ring (27) is removed, the spring force will be released. Removal of the internal components in barrel assembly (23) should be performed in a press. This is done in order to retain spring (28) and retaining ring (27).
Use a suitable press and Tooling (C) in order to compress spring (28) in barrel assembly (23).
Use Tooling (A) in order to remove retaining ring (27) from the barrel assembly.
Remove spring (28), guide (29), and pins (30) from the barrel assembly.
Illustration 22 g00714396
If necessary, remove stops (31) from swashplate (22).
Illustration 23 g00714397
Remove bearing races (32) from pump housing (6).
Illustration 24 g00714408
Use Tooling (D) in order to remove retaining ring (33) from pump housing (6).
Illustration 25 g00714407
Remove lip seal (34) from pump housing (6).
Illustration 26 g00714409
Remove bearing cup (35) from pump housing (6).
Illustration 27 g06071097
Sudden release of spring force can cause injury.To prevent the possibility of injury, follow the procedure to relieve the spring pressure.
Remove nut (40), the O-ring seal, solenoid assembly (39), and O-ring seal (42)
Remove adjustment assembly (36) and the O-ring seal from actuator assembly (3).
Remove O-ring seal (37) and thrust washer (38) from adjustment assembly (36).
Remove gasket (41) and bolts (2) from actuator assembly (3).