LEVER 8E3394 - Caterpillar

Table 1
Required Special Tools    
Part Number    Description    
6V-2197     Magnetic Transducer    
7X-1695     Cable    
7X-1171     Transducer Adapter    
9S-9082     Engine Turning Tool    Test Step 1. Install the 7X-1171 Transducer Adapter
Turn the key switch to the OFF position.
Use the 9S-9082 Engine Turning Tool to put either the No. 1 piston or the No. 6 piston at top center. Rotate the engine in the opposite direction of the correct engine rotation by the following amount:
60 Degrees
Use the following procedure for a C-10 or C-12 engine:
Remove the timing calibration plug from the right side of the cylinder block as the engine is viewed from the flywheel. The timing calibration plug is located on the No. 4 cylinder rod pocket.
Install the 7X-1171 Transducer Adapter into the hole for the plug.
Use the following procedure for a 3406E Engine:
Remove the timing calibration plug from the left side of the cylinder block as the engine is viewed from the flywheel.
Install the 7X-1171 Transducer Adapter into the hole for the plug.Results:
OK - Proceed to Test Step 2.Test Step 2. Install the 6V-2197 Magnetic Transducer on the Engine
If the crankshaft is not in the correct position when the 6V-2197 Magnetic Transducer is installed, the Magnetic Transducer will be damaged when the engine is started.
Put a 2D-6392 O-Ring Seal on the end of the magnetic transducer.Note: A small amount of clean engine oil will allow the seal to slide onto the transducer more easily.
Push the magnetic transducer through the adapter until the magnetic transducer comes in contact with the outermost portion of the crankshaft counterweight. Move the O-ring seal downward against the adapter.
Withdraw the magnetic transducer 1.0 mm (0.04 inch) and hand tighten the nut on the adapter sleeve in order to secure the magnetic transducer in place.
Connect the 6V-2197 Magnetic Transducer to the 7X-1695 Cable .Results:
OK - Proceed to Test Step 3.Test Step 3. Start the Engine and Allow the Coolant to Reach Operating Temperature
Start the engine and run at low idle until the engine has warmed up enough to exit cold mode operation. The status screen on Cat ET will display "COLD MODE" in the upper corner when cold mode operation exists. The engine will adjust idle rpm from cold mode idle to the programmed low idle rpm when cold mode operation is complete.
Check for active diagnostic codes. Use the procedures in this manual to troubleshoot and repair any active diagnostic codes before attempting a calibration check. The engine must not have any diagnostic fault conditions that are present during the timing calibration except the following condition:
22-13 Engine Speed Signal Calibration Not Performed
After the engine has warmed up, set the engine speed to 1100 rpm by the use of the cruise control switches or the accelerator pedal.Note: The engine rpm must be steady within the 1000 to 1200 rpm range in order to perform a timing calibration.Results:
OK - Proceed to Test Step 4.Test Step 4. Connect Cat ET
Connect Cat ET to the data