LEVER 8J3870 - Caterpillar

Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters    
ECM Identification Parameters    
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Description"    
   
Selected Engine Rating    
"Rating Number"    
   
"Rated Power"    
   
"Rated Peak Torque"    
   
"Top Engine Speed Range"    
   
"Test Spec"    
   
"Engine Power Trim"    
   
"FLS"    
   
"FTS"    
   
Engine Speed Parameters    
"Top Engine Limit"    
   
"Low Idle Speed"    
   
"High Idle Speed"    
   
"Engine Acceleration Rate"    
   
"Intermediate Engine Speed"    
   
Dedicated PTO Parameters    
"Engine Torque Limit"    
   
"PTO Mode"    
   
Engine Monitoring Parameters    
"Engine Monitoring Mode"    
   
"Maintenance Indicator Mode"    
   
I/O Configuration Parameters    
"Fuel Pressure Sensor"    
   
"Ether Solenoid Configuration"    
   
"Throttle Input Low Idle Duty Cycle Setpoint"    
   
"Throttle Input High Idle Duty Cycle Setpoint"    
   
"Coolant Level Sensor"    
   
"Auxillary Temperature Warning"    
   
"Auxillary Pressure Warning"    
   
Passwords    
"Customer Password #1"    
   
"Customer Password #2"    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters will cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.