LEVER (R.H.) 8M7058 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Refer to this Operation and Maintenance Manual , "Refill Capacities" to determine the type of oil pan with which your engine is equipped.Products that operate in severe operating conditions may require more frequent maintenance. Refer to this Operation and Maintenance Manual , "Severe Service Applications" to determine if the engine is operating in a severe service application.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Oil and Filter - Change
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Walk-Around Inspection
Every 250 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Starting Motor - Inspect
Initial 500 Service Hours (or at first oil change)
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Turbocharger - Inspect
Water Pump - Inspect
Every 1000 Service Hours
Engine Crankcase Breather - Clean
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Aftercooler Core - Clean/Test
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Electronic Unit Injector - Check/Replace
Engine - Clean
Engine Mounts - Inspect
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Every 585,000 L (154,540 US gal) of Fuel
Overhaul Considerations
Overhaul
Fan Drive Bearing - Replace