LEVER GP 8T0948 - Caterpillar

(1) Torque for eight bolts that fasten housings together ... 460 70 N m (340 52 lb ft)Turn the bolts by an additional 180 10 degrees.Bearing Retainer Nut (6) Torque Procedure:
1. Put 5P1730 Holding Fixture (2) in a vise and tighten the vise.2. Install retainer (3) on the 5P1730 Holding Fixture with the notch in the retainer in alignment with the dowel on the holding fixture. 3. Install nut (4) (part of 5P1730 Holding Fixture) on threaded end of holding fixture (2) and tighten against retainer (3) by hand.4. Install bearing cups (8) and (10) in pinion (5).5. Install bearing cone (11) and spacer (9) on retainer (3). 6. Install pinion (5) on the retainer.7. Install bearing cone (7) on the retainer.8. Put the lock in position on the retainer. 9. Install nut (6). While the pinion is slowly turned, use the 5P964 Spanner Wrench (12) and a torque wrench to tighten the nut to a torque of ... 70 15 N m (50 11 lb ft)10. Bend the lock so the nut is held.11. Remove nut (4).12. Remove the pinion from the holding fixture.13. Perform Steps 1 thru 12 for all four pinions before installation in the housing. After pinions are installed in the housing, the torque needed to turn the assembled gears must not be more than ... 50 N (37 lb ft)