LEVER 9P0391 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     2    
B     -     Guide Bolt (M12 X 1.75 by 120 mm)     1    
C     9S-3263     Thread Lock Compound     1    
Illustration 1 g01125043
Raise the temperature of ring gear (3) .Note: Do not use a torch to heat the ring gear.
Position ring gear (3) on flywheel (2) with the part number toward the crankshaft. Use a soft hammer in order to seat the ring gear against the shoulder of the flywheel. Allow the ring gear to cool.
Install Tooling (A) and a suitable lifting device on flywheel (2). The weight of flywheel (2) is approximately 23 kg (50 lb).
Position flywheel (2) on Tooling (B) .
Apply Tooling (C) to the threads of bolts (1) .
Install bolts (1). Remove Tooling (B) and install remaining bolt (1). Tighten the bolts evenly to a torque of 120 20 N m (90 15 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".