AVSPARE.COM
parts catalog

LIFT G 0543480 - Caterpillar



0543480 LIFT G Caterpillar parts LIFT
Rating:
76
Alternative (cross code) number:
CA0543480
054-3480
0543480
Caterpillar 0543480 LIFT G
Weight: 8 pounds 3 kg.

Buy LIFT G 0543480 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Spin-On Filter
Illustration 1 g06336738
Fully open the engine hood. Secondary fuel filters are on the right side of the machine.
Open or remove right side engine panel.
Remove the fuel filters. Dispose of the used filters properly.
Clean the filter mounting base with a clean, nonflammable solvent. Ensure that the O-ring sealing surface is free of debris.
Lubricate the seal of the new fuel filters with clean diesel fuel. Install the new fuel filters hand tight until the seal of the fuel filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base.Note: There are rotation index marks on the fuel filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten the fuel filter, use the rotation index marks as a guide.
Tighten the filter according to the instructions that are printed on the filter. Use the index marks as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter.Note: Use a Cat strap wrench to turn the filter. Ensure that the installation tool does not damage the filter.
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Prime the fuel system.Reference: Refer to Operation and Maintenance Manual, "Fuel System - Prime" for the correct procedure.
Reinstall the right side engine panel, and fully close the engine hood.Cartridge Filter
Fully open the engine hood. The secondary fuel filters are on the right side of the machine.
Clean around the secondary/tertiary fuel filter housings and base. Inspect for any leakage between the filter housings and filter base in the area of the threads. Fuel leakage at this interface may indicate damage or contamination in the threads.
Illustration 2 g06328402
Attach the drain line to drain valve (2) at the bottom of filter housing (1).
Loosen the drain valve and bleed screw to drain fuel from the housing. Catch the fuel in a suitable container.
Tighten the drain valve once fluid flow has stopped.
Swap the drain line to second housing/drain valve and repeat the previous 2 steps to drain the second fuel filter housing.
Hand tighten the second drain valve and bleed screw once fluid flow has stopped.
Use a wrench or strap wrench to loosen and remove the filter housings from the base.Note: The filter elements are retained in the filter housings and will be removed as an assembly.
Remove the old filter elements from the filter housings by loosening the drain valves and unscrewing the filter elements from the housing. A small amount of the residual fuel will remain in the bottom of the housing which must be dumped into a suitable container.
Clean the inside of the filter housings and filter base with a lint free towel. Inspect sealing surfaces of the filter housings and filter base to ensure that no seal material from the old filters is present.
Lubricate the sealing surfaces of the new filter elements with clean diesel fuel. Install the new filters into the filter housings. The new filters


Parts lift Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.