AVSPARE.COM
parts catalog

LIFT G 0543721 - Caterpillar



0543721 LIFT G Caterpillar parts LIFT
Rating:
16
Alternative (cross code) number:
CA0543721
054-3721
0543721
Caterpillar 0543721 LIFT G
Weight: 1 pounds 0 kg.

Buy LIFT G 0543721 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Introduction
The Program Module in the 9U6701 Ultrasonic Wear Indicator II contains the software instructions that control the indicator operation and display.The Program Module is available in different languages and can be easily changed, using the procedures in this publication. This feature allows the indicator display to be understood by users in their own language.The following list of available Program Modules are in the order of Form Number, Language, and Software Version Number Suffix:NEXG4525 (English) ENFXG4515 (French) FNGXG4525 (German) GNSXG4525 (Spanish) SNPXG4525 (Portuguese) PThe software version number installed in the indicator can be viewed without removing the back cover. Refer to "Viewing the Software Version Screen," in this publication, for a screen display.When you order any of these form numbers, you will receive the latest version of the Program Module and installation instructions.The label on the Program Module shows the software version number. If changes are made to the software, the version number will change. Refer to "Viewing the Software Version Screen," in this publication.Viewing The Software Version Screen
The version number of the software that is in use in the Ultrasonic Wear Indicator can be viewed on the display in the following manner: 1. Turn the indicator OFF.2. Press and hold down the LOC/MACH key and press ON/OFF to turn the indicator ON. Example of display for English versionWhen the indicator comes on the software version screen is displayed as shown above. The examples shown are for the English versions.Replacement Of The Program Module
All information which is stored in the indicator will be lost and cannot be retrieved when the program module is changed.If it is desirable to save this information it MUST be recorded before changing the module.
The program module is packaged in a container to protect it from static discharge.Before touching the module in the container, or removing from the indicator, be sure to discharge any static electricity in your body by touching a grounded surface.
Back view of 9U6701 Ultrasonic Wear Indicator with cover installed.1. Remove six screws (1) from cover (2).2. Remove cover (2).
Back side of 9U6701 Ultrasonic Wear Indicator with cover removed for access to the Program Module.3. Locate small connector (3) near the upper right corner of the battery holder with two wires coming from it. Separate connector (3) by pulling gently on the plug.This will disconnect the batteries from the indicator to prevent damage while changing the program module.
Remove the Program Module with fingers ONLY by pulling up on the tabs on each end of the Program Module.Do not use any mechanical tool to remove the Program Module or damage may occur.
4. Locate and remove Program Module (4) in the center of the large printed circuit board above the batteries.5. Install the new Program Module into the empty socket. The Module and socket are keyed so it can only be installed in the correct (seated) position.6. Locate the two bare pins which are still attached to the printed circuit board on connector (3) which were separated in Step 3. Use a screwdriver or


Parts lift Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.