LIFT CYLINDER GROUP 9J2399 - Caterpillar

9J2399 LIFT CYLINDER GROUP Caterpillar parts 955K, 955L

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA9J2399
9J-2399
9J2399

Weight: 250 pounds 113 kg.

Buy LIFT CYLINDER GROUP 9J2399 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Kit King - CAT Caterpillar 3367352 Aftermarket Hydraulic Cylinder Seal Kit

$35.34

29 Oct 2021

Amazon.com

Kit King - CAT Caterpillar 3367352 Aftermarket Hydraulic Cylinder Seal Kit
Kit King USA 2.5 Inch Rod & 5.5 Inch Bore || Caterpillar Equipment Types: Scrapers & More || Equip. Models: 12F, 14E, 16, 621/B, 623/B, 627/B, 824/B, 922A/B, 941/B, 944/A, 950, 951B, 951C, 955, 955K/L, 977K/L, 980B, 992, 992B, D4D, D4E, D5B, D6D, J621 & More || Typical Hydraulic Applications: Bucket, Lift, Load, Ripper, Tilt || Cylinders: 5J6342, 6J3308, 7J9690, 7J9695, 7J9741, 7J9742, 8J0204, 8J5761, 8J9446, 9J2399, 9J2401, 9T1803 & More

Number on catalog scheme:

Caterpillar 9J2399 Parts scheme LIFT CYLINDER GROUP

For full view, you need register

Compatible equipment models: 9J2399:

TRACK LOADER 955K 955L Caterpillar

Information:

Remove Valves
START BY:a. remove cylinder head assembliesb. remove precombustion chambers/direct injection adapters 1. Put springs (1) under compression with tool (A).2. Remove the locks from the valves.3. Remove tool (A), the rotocoil, spring and valve. If the valves can be used again, put identification marks on the valves for location at installation. 4. Check the spring force with tool (B). Spring force must be 344.7 17.3 N (77.5 3.9 lb.) when the length of spring under force is 54.99 mm (2.165 in.).5. Do Steps 1 through 4 again for the remainder of the valves.Install Valves
1. Put clean engine oil on the valve stem. Install spring (2), rotocoil (1) and the valve. 2. Put the springs under compression with tool (A).3. Install locks (3) with the thick end up.
Locks can be thrown from the valve when the spring compressor is released if the locks are not in their correct position.
4. Remove the compressor, and hit the valve with a soft hammer to be sure the locks are in their correct position.5. Do Steps 1 through 4 again for the remainder of the valves.END BY:a. install precombustion chambers/direct injection adaptersb. install cylinder head assemblies