LIFTER AS 5P9832 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-9200     Lever Puller Hoist        
140-7742 Sleeve        
B     1U-6221     Hydraulic Torque Wrench Gp     1    
385-8479 Hydraulic Pump and Motor Gp (110V)     1    
384-8916 Hydraulic Pump and Motor Gp (230V)        
132-8154 Wrench Link     1    
132-8143 Wrench Link     1    
9U-6539 Socket 36mm     1    
214-1126 Socket 36mm     1    
C     180-3034     Jack Stand Gp     1    
180-3033 Jack Stand Gp     2    Start By:
Remove the bottom guard.
Release the hydraulic system pressure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the proper draining and filling procedures.
Illustration 1 g02960557
Install Tooling (A) and a suitable lifting device to winch (2). The weight of winch (2) is approximately 873 kg (1925 lb).
Use Tooling (B) in order to remove bolts (1) .
Illustration 2 g02960597
Illustration 3 g02960616
Position winch (2) on Tooling (C) .
Disconnect harness assemblies (3) from winch (2) .
Illustration 4 g02960620
Disconnect hose assemblies (4) and (5) .Install
Install winch (2) in the reverse order of removal.