AVSPARE.COM
parts catalog

LIFTING GP- 3C8028 - Caterpillar


3C8028 LIFTING GP- Caterpillar parts
Rating:
51
Alternative (cross code) number:
CA3C8028
3C-8028
3C8028
Caterpillar 3C8028 LIFTING GP-
Weight: 0.010 pounds 0 kg.

Buy LIFTING GP- 3C8028 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Gp 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that all of the parts of the engine oil pump are thoroughly clean prior to assembly. Note: Lubricate all internal parts of the engine oil pump with clean engine oil.
Illustration 1 g01271413
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install oil pressure relief plunger (12) and spring (13) in oil pump body assembly (7). Install oil plug (14).
Illustration 2 g01172656
Install shaft assembly (11) in oil pump body assembly (7).
Install shaft assembly (8) in oil pump body (9).
Position oil pump body (9) on oil pump body assembly (7) and install bolts (10).
Illustration 3 g01271430
Press drive gear (6) on shaft assembly (8) until drive gear (6) is flush with the end of shaft assembly (8).
Install shaft (5) of engine oil pump on oil pump body assembly (7). Install the bearing in idler gear (4) with Tooling (A). Install the bearing so the distance between the hub bolt face of idler gear (4) and the bearing is 0.75 0.25 mm (0.030 0.010 inch).
Install idler gear (4) on shaft (5) of engine oil pump. Install the washer and bolt (3). Tighten bolt (3) to 70 15 N m (52 11 lb ft).
Illustration 4 g01271408
Check the condition of the gasket that is used in tube assembly for the pickup tube (1). If the gasket is damaged, replace the gasket. Install the gasket and tube assembly for the pickup tube (1).
Check the condition of the O-ring seal that is used in outlet elbow (2). If the O-ring seal is damaged, replace the O-ring seal. Install the O-ring seal and outlet elbow (2). End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.