LIFTING GP 5425989 - Caterpillar

Illustration 5 g00513213
This view is from the underside of the machine.
Place two cover assemblies (6) in the cover assembly's original position on the underside of the undercarriage frame assembly. Install bolts (5) .Installation Procedure For The Swivel On CIPI Undercarriage Arrangements Which Are Based On 325C Track Type Excavators
Table 3
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-2674     Vacuum Cap     1    
B     138-7573     Link Bracket     2    Note: O-rings, gaskets and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Make sure that the threaded holes in the undercarriage frame assembly for mounting the swivel joint are clean and free of dirt and debris.
Apply a bead of 1U-8846 Liquid Gasket to the surface of the undercarriage frame assembly prior to the installation of the swivel joint.
Illustration 6 g00687476
Fasten Tooling (B) and a hoist to the swivel. Install the swivel on the machine. The weight of the swivel is approximately 43 kg (95 lb).
Make sure that the identification mark on the bottom face of the swivel faces toward the front of the machine.
Illustration 7 g00690963
Install the cap to the hydraulic tank. Attach Tooling (A) to the hydraulic tank.Note: Hook up the air to Tooling (A) in order to create a vacuum in the hydraulic system. This will minimize the leakage from the hose assemblies.
Illustration 8 g00687510
Apply 9S-3263 Thread Lock Compound on the threads of bolts (10). Install the washers and bolts (10) .
Connect hose assemblies (11) to the tee. Tighten hoses (11) to a torque of 80 7 N m (59 5 lb ft).
Install tee fitting (13) in the swivel joint. Tighten the tee to a torque of 40 5 N m (30 4 lb ft).
Connect hose assemblies (12) to tee (13). Tighten hoses (12) and tee (13) to a torque of 40 5 N m (30 4 lb ft).
Install the split flanges, the washers, and the bolts in order to connect hose assemblies (9) .
Remove Tooling (B) from the swivel.
Install the rubber boot on the swivel.
Install the retainer. Install the washers and bolts (5). Tighten the bolts to a torque of 37 4 N m (27 3 lb ft).
Install hose clamp (6). Tighten the hose clamp to a torque of 5.4 0.5 N m